S8911 case and gear as is
It contains a new design NAMIKI brushless motor for better response.
It has the same power and speed as the 8911 Coreless servos.
30% reduction in heat during use.
Recommended for Aerobatic planes and Jets up to 120cc.
 
[Stall Torque]
28.3kgs (6.6V) / 31.7kgs (7.4V) / 36.0kgs (8.4V)kg・cm
392.8oz (6.6V) / 440.4oz (7.4V) / 499.9oz (8.4V)oz・in
[Speed]
0.13 (6.6V)/0.12 (7.4V)/0.10 (8.4V) Sec/60°
[Weight]
79 g / 2.79 in
[dimensions]
40 x 20 x 41.05 mm
[Length of lead harness]
300mm
[Operating Voltage]
4.5V - 8.5V
■programmable
Neutral, endpoint,gain etc(Works with PWM XBUS)120°150°180°(Works with PWM XBUS)Synchronize(Works with PWM XBUS)■Super steel full metal gear(Gear B brass)■wide valtage
■Brushless motor
Almost same size as S8911 . Easy to fit ARF mount size. Because OLD JR design was 21mm but our new design is 20mm.<Best setting for super light Airplanes Ex .3D airplanes IMAC airplanes . Jets and composite small control surface >Holding +5Damping +20Dead band 0Boost +100 to 200You can adjust by JR TX or Our New programmer .
Stock setting is OK. But you may get a better feeling if you adjust.
 
Important Notes on Using Our Servos
Our servos are programmed to operate with high precision and sensitivity.
Because of this, if there are any obstructions within the servo’s range of motion and it is unable to move as commanded by the transmitter, the servo may experience excessive load. This can result in damage to the internal circuit board due to overheating.
When installing the servo for throttle, aileron, or other control surfaces, please make sure to leave a small amount of free play between the servo travel range and the mechanical movement range. This helps prevent any binding or overloading of the servo.
 
The firmware in a 2k servo verifies the position of the servo arm two thousand times each second, while the firmware found in previous servos verify the arm's position one thousand times per second.This greater number of verifications makes for a very precise servo, and gives it a more "solid" feel.
It is recommended to use a booster cable with 2k servos to ensure steady voltage at all times.