[Stall Torque]   
         2.5kgs  (6.6V) / 2.8kgs  (7.4V) / 3.2kgs (8.4V)kg・cm
         34.7oz (6.6V) / 38.9oz (7.4V) / 44.1oz (8.4V)oz・in
[Speed]
         0.06 (6.6V)/0.05 (7.4V)/0.04 (8.4V) Sec/60°
[Weight]
26 g / 0.92 oz
[diemension]
38.5 x 15 x 26.5 mm
[Length of lead harness]
300mm
[Operating Voltage]
4.5V - 8.5V
■Neutral: 1500
■programmable
 ID Change
Reverse
Neutral
Travel Adjust
Holding
Damping
Dead Band
Boost
Alarm Level
Alarm Delay
Angle (120, 150 and 180)
Slow Start
Stop Mode
 
Important Notes on Using Our Servos
Our servos are programmed to operate with high precision and sensitivity.
Because of this, if there are any obstructions within the servo’s range of motion and it is unable to move as commanded by the transmitter, the servo may experience excessive load. This can result in damage to the internal circuit board due to overheating.
When installing the servo for throttle, aileron, or other control surfaces, please make sure to leave a small amount of free play between the servo travel range and the mechanical movement range. This helps prevent any binding or overloading of the servo.