Standerd Servo with XBus Programmable 
We do not recommend this servo for use on  big airplanes or jets.
The servo was designed for robots, or industrial purpose, so use of RC cars or small robotic toys would be perfect.
 
[Torque]95.4 (6.6V) / 106.9 (7.4V) / 121.4 (8.4V) oz-in
            6.9 (6.6V) / 7.7 (7.4V) / 8.7 (8.4V) kg･cm
[Speed] 0.21 (6.6V) / 0.19 (7.4V) / 0.17 (8.4V) Sec/60°
[Dimensions] 1.48 x 0.75 x 1.52 in / 37.5 x 19 x 38.5 mm
[Weight] 1.59 oz / 45 g
[Voltage Range] 6.0V-8.5V
Slow start function
Ultem Gear
With Ball Bearing (Single)
 
*Wide Voltage
* Single ball bearings
* Slow start function
* Compatible with any radio using PWM control
* XBus compatible allowing *120 to 180 deg travel
* featureYou can adjust Damping,Hold,Deadband...etc
* Do not use this servo outside of the specified voltage.
* If used on a large and Heavy control surface
*Try to adjust Damping.Hold .Dead band.Boost etc... You will set it up perfect condition.(use RX Xbus port    and Xbus TX)
 
Important Notes on Using Our Servos
Our servos are programmed to operate with high precision and sensitivity.
Because of this, if there are any obstructions within the servo’s range of motion and it is unable to move as commanded by the transmitter, the servo may experience excessive load. This can result in damage to the internal circuit board due to overheating.
When installing the servo for throttle, aileron, or other control surfaces, please make sure to leave a small amount of free play between the servo travel range and the mechanical movement range. This helps prevent any binding or overloading of the servo.