6.6V servo, good with Li-Fe battery set up
[Control Signal Type] PWM Only
 
[Stall Torque]   
3.0 kgf-cm (6.6V) / 41.7 oz-in (6.6V)
[Speed]
0.1  Sec/60° (6.6V)
[Weight]
25 g / 0.88 oz
[dimensions]
35 x 15 x 30 mm / 1.38 x 0.59x 1.18 in
[Length of lead harness]
250mm
[Operating Voltage]
4.8V - 7.0V (Li-Fe 6.6v recommended）
 
■Coreless motor
■Full metal gear
■Heat sink case
■Double ball bearing 
■Neutral : 1500usec
 
Important Notes on Using Our Servos
Our servos are programmed to operate with high precision and sensitivity.
Because of this, if there are any obstructions within the servo’s range of motion and it is unable to move as commanded by the transmitter, the servo may experience excessive load. This can result in damage to the internal circuit board due to overheating.
When installing the servo for throttle, aileron, or other control surfaces, please make sure to leave a small amount of free play between the servo travel range and the mechanical movement range. This helps prevent any binding or overloading of the servo.